DSC PC1404 v1.1 Bedienungsanleitung PDF herunterladen (Seite 19)

NOTE: If you suspect that a fire alarm has been transmitted and that there is no fire

condition, call the monitoring station to avoid an unnecessary response. If a fire condition

is apparent, follow your evacuation plan immediately. If the alarm sounds at night, evacu-

ate immediately.

User Function Commands

First disarm the system then enter [Master Code]

The command is used to gain access to the following list of Master functions of the system.

[1] Time and Date

Enter 4 digits for 24 Hour System Time (HH-MM). Valid entries are 00-23 for the hour and 00-59 for

minutes.

Enter 6 digits for the Month, Day and Year (MM-DD-YY)

[2] Auto-arm Control

Pressing [2] while in the User Function menu will enable (3 beeps) or disable (one long beep) the

Auto-arm feature. With this feature enabled, the panel will automatically arm in the Away mode

(Stay Away zones active) at the same time each day. The auto-arm time is programmed with the

[][6][Master Code][3] command.

[3] Auto-arm Time

The system can be programmed to arm at a programmed time each day. Upon entry of this section,

enter 4 digits for the 24-hour Auto-arm time.

At the selected auto-arm time, the keypad buzzers will sound for a programmed amount of time

(programmable by the installer only) to warn that an auto-arm is in progress. The bell can also be

programmed to squawk once every 10 seconds during this warning period. When the warning

period is complete, the system will arm with no exit delay and in the Away Mode.

Auto-arming can be cancelled or postponed by entering a valid access code only during the pro-

grammed warning period. Auto-arming will be attempted at the same time the next day. When the

auto-arming process is cancelled or postponed, the Auto-arm Cancellation Reporting Code will be

transmitted (if programmed).

If arming is inhibited by one of the following, the Auto-arm Cancellation transmission will be com-

municated.

- AC/DC Inhibit Arm

- Latching System Tampers

- Zone Expander Supervisory Fault

[4] System Test

The system’s Bell Output (2 s), Keypad Lights and Communicator are tested. This test will also mea-

sure the panel’s standby battery.

[5] Enable DLS / Allow System Service

If enabled, the installer will be able to access Installer Programming by DLS. In case of DLS access this

provides a window where rings will be detected by the panel. The DLS window will remain open for

6hrs, during which time the installer will be able to enter DLS an unlimited number of times. After

the 6-hr window has expired, Installer’s Programming will be unavailable again until the window is

re-opened.

[6] User Call-up

If enabled by the Installer, the panel will make 1 attempt to call the downloading computer. The

downloading computer must be waiting for the panel to call before downloading can be performed.

[7] For Future Use

[8] For Future Use

Use the arrow (< >) keys to find the following message and press

the [] key to select

Command O/P 2

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

DSC PC1404 v1.1 Bedienungsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme DSC PC1404 v1.1