7
The Programming Sections in this document are accessed via panel Section for Ethernet/GPRS Programming.
Enter: [*][8][installer code][851][###], Where ### is the 3 digit Section number referenced in this Program-
ming section. The worksheet at the end of this document can be used to record new values when programming
changes have been made from their default values. Default values are provided for each Section.
NOTE: Programmed values can not be modified using the keypad. Installers may review/record pro-
gramming Option values at the keypad.
Programming Options
[011] Installer Code
Default (CAFE)
Program your installer code for this IT-230 module. The installer code is required whenever programming of the
IT-230 module is required. Valid range: 0000 - FFFF.
[021] Account Code
Default (FFFFFF)
The Account Code is included when transmitting events generated by the IT-230. (e.g., Panel Absent Trouble). It is
recommended that the IT-230 Account Code be the same as the Panel Account Number. Valid range: 00000
1
-
FFFFF
E
. If 4 digit account codes are needed the 2 lowest digits shall be programmed as FF;(e.g., Account Code
1234 is programmed as:1234
FF
). Programming this Section as all 0 or all F will cause a Module Configuration
Trouble (Trouble LED = 12 flashes).
NOTE: 12 flashes are indicated on the IT-230 only. This status is NOT communicated to the panel.
[022] Communications Format
Default (04)
The module can be configured to send IT-230 Events in SIA or CID format. Program
03
for CID. Program
04
for
SIA. The SIA communication format follows the level 2 specifications of the SIA Digital Communication Standard -
October 1997. This format will send the Account Code programmed in Section [021] along with its data transmis-
sion. The transmission will look similar to the following at the receiver:
Nri0 ET001
Where:
N
= New Event;
ri0
= Partition/Area identifier;
ET
= [023] Panel Absent Trouble;
001
= Zone 001.
IT-230 Communications Reporting Codes
[023] Panel Absent Trouble
Default (FF)
Program 00 to disable this event or FF to enable. This event will occur when communications with the panel have
been lost for more than 60 seconds.
[024] Panel Absent Trouble Restore
Default (FF)
Program 00 to disable this event or FF to enable. This event will occur when communications with the control panel
have resumed.
Interactive Options
[651] Interactive Account Code
Default (000000)
This section is programmed with the interactive Account Code of the IT-230.
[661] Interactive Baud Rate
Default (05)
This section is programmed with the baud rate used. Valid entries are provided in the table below. Default baud
rate is 115.2 KB.
IT-230 PROGRAMMING SECTION
Table 5: Communications Reporting Codes
Event
SIA
Identifier
SIA
Reporting
Code
CID
Qualifier
CID
Event
Code
CID
Reporting
Code
CID
User/
Zone
[023] Panel Absent Trouble ET 001 1 3 55 001
[024] Panel Absent Trouble Restore ER 001 3 3 55 001
Table 6: Interactive Baud Rate Settings
HEX Value 01 02 03 04 05
Baud Rate
9600 19200 38400 57600 115200
(12 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern