DSC PC51O Installationshandbuch

InstallationManual• W A R N I N G •This manual contains information on limitations regarding product useand function and information on the limitation

8Important Note about Keypad [∗∗∗∗∗] CommandsThe [∗] commands will not function when the system is disarmed and the bell or siren is active. In order

9PROGRAMMING GUIDEWith the system disarmed, enter [∗][8][Installer’s Code]. The system can only be programmed while it isdisarmed. The default Insta

10PROGRAMMING SECTIONS[1] Zone DefinitionsEnter four 2-digit numbers in this section to determine the operating characteristics of each zone.Zone Defi

11[2] System TimesThree system times are programmed in Section [2]; each time requires a 3-digit number. Do not press the [#]Key during data entry.[1

12[8] [F], [A] and [P] Key Alarms: The PGM output switches to ground when any of the keypad alarms aregenerated by pressing the [F], [A] or [P] Keys.

13FOR THE RECORDCustomer ___________________________________________________________________________________Address __________________________________

14[1] Zone Definitions Page 10NOTE: When defining zones, assign delay zones first, then assign the other types.Default0 0 Zone 10 1 Zone 20 2 Zone

15HOOK-UP DIAGRAMAUX 1 AMPBELL 5 AMPBATT 5 AMPDO NOT REPLACE FUSESWITH HIGHER VALUESTHAN SHOWNPC510BELL/SIREN1A MAX.OBSERVE POLARITY!BATTERY12V GELL C

LIMITED WARRANTYDigital Security Controls Ltd.’s liability for failure to repair the prod-uct under this warranty after a reasonable number of attempt

WARNING Please Read CarefullyNote to InstallersThis warning contains vital information. As the only individual in contactwith system users, it is your

©1997, 2002 Digital Security Controls Ltd.Toronto, CanadaPrinted in Canada 29000864 R11-800-387-3630

1TABLE OF CONTENTSINTRODUCTION 2Features ...

2INTRODUCTIONFEATURES• Fully featured security system with TroubleSupervision, Alarm Memory, Master Code and 3programmable Access Codes, Quick-Arming

3INSTALLATIONMounting the PanelSelect a dry location close to an unswitched AC source and a ground connection.Remove the printed circuit board, mounti

4WiringNOTE: Complete all wiring to the control panel before applying battery or AC power.Burglary Zone WiringBurglary zone definition, (for example,

5KEYPAD FUNCTIONSIntroductionThe Keypad provides complete control of the PC510 security system. The system can be completelyprogrammed from the keypa

6DisarmingEnter the premises through the designated Entry-Exit door. The keypad will sound a tone to indicate that thesystem must be disarmed. Go to

7[∗]+[5]+[Master Code]: Program Access CodesThe [∗][5][Master Code] command allows the user to program the Master Code and 3 additional AccessCodes.E