DSC MAXSYS PC4020 Bedienerhandbuch PDF herunterladen (Seite 27)

Section 4: Access Control

Your installer will customize access levels 02-63 to suit your purposes.

Assigning access level 00 means that the user will never have access to

a given area. Assigning access level 01 means that the user will always

have access to a given area.

To program access level, perform the following. Your starting point

should be from the Program Code menu (from Step 3 above):

1. Use the right arrow (>) key to scroll to the following display:

Select (4) < >

Access Level

Press [

] or [4].

2. The display will read “Access Level Enter 00-63.” The numbers

“01”will be in the bottom right-hand corner of the display. This means

that the system has assigned Access Level 01 by default to the user

and the user will always have access. To assign another access level,

enter a 2-digit number from 00-63, corresponding to the new access

level.

3. Once the access level has been entered, press [#]. The display will

return to “Select (4) Access Level.”

User Options

Once the access level has been programmed, three different user

options must be programmed. These options are the following:

CarCar

Car

d Vd V

d V

alidalid

alid: This option allows the user’s access card to become active

on the system. Make sure the access card number is also programmed.

Prvleged CarPrvleged Car

Prvleged Car

d: A privilege card user will be able to access areas via an

access card entry point when general access is prohibited. This option,

when enabled, will also give the user the ability to grant access to users

who have a “Wait for Privilege” access card (see next option).

ait for Prvlait for Prvl

ait for Prvl: This option will restrict the user’s access to areas via an

access card entry point when access is prohibited. A Wait for Privilege

user, however, can gain access to the system under the following

condition: A Privilege cardholder must present their card after the Wait

for Privilege user swipes theirs.

Table 2-1 shows which codes have these options turned on by default.

To change the user option settings for these features, follow the

directions outlined in Section 2.3 “Change User Code Options.”

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

DSC MAXSYS PC4020 Bedienerhandbuch Seite 27

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein DSC MAXSYS PC4020