DSC MAXSYS PC4020 Bedienerhandbuch PDF herunterladen (Seite 8)

For Multi-Partition Access Codes

When a multi-partition access code is entered, you must tell the system

which partition(s) you wish to arm. The system will only offer to arm the

partitions for which your code is programmed. Once you have entered

your code, the display will read:

(0) TO ARM < >

(Partition Label) R

The lower right hand corner of the display will show the partition status

using the letter “R” for the partitions which are Ready to be armed, “A”

for the partitions which are already Armed and “N” for those partitions

which are not yet secured. To arm the partition indicated on the display,

press the number in parentheses (in this case, [0]) or press the [

] key. The

exit delay will begin, providing a period of time for you to exit the partition

without causing an alarm. Once the exit delay has expired, the partition

will be armed.

If you wish to arm another partition, use the arrow (< >) keys to scroll

though the partitions available to be armed by your access code. To select

a partition, enter the number indicated in parentheses, or press the [

]

key. If you have selected another partition, the keypad will display the

following message:

Select (0) < >

Arm Partition R

To arm the partition, enter the number indicated in parentheses, or press

the [

] key. The exit delay will begin in the other partition and the keypad

will read:

Exit Delay

In Progress

This display will remain for a few seconds until the keypad returns to the

previous “(0) To Arm…” display.

1.3 Alternate Arming Methods

Away Arming

Arming the system in the Away mode will have all interior zones and

perimeter zones active. If motion is detected in the interior zones, or if

one of the perimeter zones is violated, the alarm sequence will begin. To

arm in the Away mode, enter your access code, select the partition(s) to

be armed and exit the premises through a designated exit/entry door.

The system will recognize that you have left the premises. Once the exit

delay expires, the system will be armed in the Away mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Keine Kommentare

DSC MAXSYS PC4020 Bedienerhandbuch Seite 8