DSC MAXSYS PC4020 Bedienerhandbuch PDF herunterladen (Seite 11)

Section 1: General System Operation

1.7 Bypassing Zones

You can use zone bypassing when access is needed to part of the protected

area while the system is armed. Zones which are temporarily out of service

due to damaged wiring or contacts may be bypassed to allow system

arming until repairs can be made.

Bypassed zones will not cause an alarm. Zones cannot be bypassed once

the system is armed. Bypassed zones are automatically canceled each time

the system is disarmed and must be reapplied before the next arming.

NOTE: For security reasons, your system administrator may program

the system to prevent you from bypassing certain zones.

Bypassing zones reduces your security protection. If you are bypassing a

zone due to damaged wiring or contacts, please notify your system

administrator or call a service technician immediately so that the problem

can be resolved and your system returned to proper working order.

To bypass zones:

1. Enter [

] [1]. You may be required to enter your access code.

2. A menu will outline the various bypassing options. Use the arrow (<

>) keys to scroll through the options. When you find the correct

option, press the [

] key to select it, or press the corresponding

number in parentheses. The bypassing options are as follows:

[0] Bypass Open Zones[0] Bypass Open Zones

[0] Bypass Open Zones – This section will only display the zones which

are currently open or bypassed. Use the arrow (< >) keys to scroll through

these zones. Zones that are open will be indicated by an exclamation (!)

mark in the lower right hand side of the keypad display. To select a zone

to be bypassed, press the [

] key. A “

” will appear next to the zone label

to indicate that the zone has been bypassed. When you are done selecting

zones, press [#] to exit.

[1] Bypass Zones[1] Bypass Zones

[1] Bypass Zones – This selection takes you immediately to bypassing

zones. Use the arrow (< >) keys to find the zone to be bypassed and press

the [

] key to select it. A “

” will appear next to the zone label to indicate

that the zone has been bypassed. When you are done selecting zones,

press [#] to exit.

[2] Clear Bypasses[2] Clear Bypasses

[2] Clear Bypasses – This selection will allow you to turn bypassing off

for all of the zones in your partition.

[3] Recall Bypasses[3] Recall Bypasses

[3] Recall Bypasses – This selection will automatically bypass the same

group of zones which were bypassed the last time the partition was armed.

[4] Pr[4] Pr

[4] Pr

evious Menuevious Menu

evious Menu – This selection will return the display to “Enter Code

to Arm System.” From here, you will be able to arm the system.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

DSC MAXSYS PC4020 Bedienerhandbuch Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein DSC MAXSYS PC4020